Display Session Table Ipv6 - H3C MSR Series Command Reference Manual

Start time: 2011-07-29 19:12:33
Initiator->Responder:
Responder->Initiator:
Total sessions found: 2
Table 138 Command output
Field
Initiator
Responder
DS-Lite tunnel peer
VPN instance/VLAN ID/Inline
ID
Protocol
Source security zone
State
Application
Start time
TTL
Initiator->Responder
Responder->Initiator
Total sessions found

display session table ipv6

Use display session table ipv6 to display information about IPv6 unicast session entries that match
specific criteria.
Syntax
Centralized devices in standalone mode:
TTL: 55s
1 packets
0 packets
Description
Information about the unicast session from the initiator to the responder.
Information about the unicast session from the responder to the initiator.
Address of the DS-Lite tunnel peer.
When the unicast session does not belong to any DS-Lite tunnel, this field
displays a hyphen (-).
MPLS L3VPN instance to which the unicast session belongs.
VLAN and inline to which the session belongs during Layer 2 forwarding.
If a parameter is not specified, a hyphens (-) is displayed for the proper
field.
Transport layer protocol:
•
DCCP.
•
ICMP.
•
ICMPv6.
•
Raw IP.
•
SCTP.
•
TCP.
•
UDP.
•
UDP-Lite.
The number in the brackets indicates the protocol number.
Security zone to which the inbound interface belongs. If the inbound
interface does not belong to any security zone, this field displays a hyphen
(-).
Unicast session state.
Application layer protocol, FTP or DNS.
If it is an unknown protocol identified by an unknown port, this field displays
OTHER.
Unicast session establishment time.
Remaining lifetime of the unicast session, in seconds.
Number of packets and bytes from the initiator to the responder.
Number of packets and bytes from the responder to the initiator.
Total number of found unicast session entries.
883
60 bytes
0 bytes