Lapb Timer; Lapb Window-Size - H3C MSR 20-20 Command Reference Manual

Example

lapb timer

Syntax
View
Parameter
Description
Example

lapb window-size

Syntax
# Set the LAPB parameter N2 on Serial 2/0 to 20.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] lapb retry 20
lapb timer { t1 t1-value | t2 t1-value | t3 t3-value }
undo lapb timer { t1 | t2 | t3 }
Interface view
t1 t1-value: Value of timer T1, in the range 2 to 64000 milliseconds. The default is
3000 milliseconds.
t2 t2-value: Value of the timer T2, in the range 1 to 32000 milliseconds. The
default is 1500 milliseconds.
t3 t3-value: Value of the timer T3, in the range 0 to 255 seconds. The default is 0
seconds.
Use the command to configure the LAPB timers T1, T2 and T3.
lapb timer
Use the undo lapb timer
T1 is the retransmission timer. When T1 expires, DTE (DCE) will start
retransmission. The value of T1 shall be greater than the maximum time between
the sending of a frame and the receiving of its response frame.
T2 is the reception timer. When it expires, the DTE/DCE must send an
acknowledgement frame so that this frame can be received before the peer
DTE/DCE T1 timer expires (T1Š2*T2).
T3 is an idle channel timer, when it expires, the DCE reports to the packet layer
that the channel stays idle for a long time. T3 should be greater than the timer T1
(T3>T1) on a DCE. When T3 is 0, it indicates that it does not function yet.
# Set the LAPB timer T1 on Serial2/0 to 2000 milliseconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] lapb timer t1 2000
lapb window-size k-value
undo lapb window-size
command to restore their default values.
435