Garp Timer Leaveall - H3C MSR 20-20 Command Reference Manual

Related command:
Example

garp timer leaveall

Syntax
View
Parameter
Description
When restoring the default GARP timers, you are recommended to do that on the
timers in the order of hold, join, leave, and leaveall.
When configuring GARP timers, note that their values are dependent on each
other and must be a multiplier of five centiseconds. If the value range for a timer is
not desired, you may change it by tuning the value of another timer as shown in
the following table:
Table 53 Dependencies of GARP timers
Timer Lower limit
Hold 10 centiseconds
Join Not less than two times the hold timer
setting
Leave Greater than two times the join timer
setting
Leaveall Greater than the leave timer setting
display garp timer.
# Set the GARP join timer to 25 centiseconds, assuming that both the hold timer
and the leave timer are using the default.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] garp timer join 25
garp timer leaveall timer-value
undo garp timer leaveall
System view
timer-value: Leaveall timer setting, in the range 65 to 32765 (in centiseconds).
Note that the setting of the leaveall timer must be a multiple of 5 and must be
greater than the leave timer settings of all the ports.
Use the
garp timer leaveall
Use the undo garp timer leaveall
fail if the default is less than the setting of the current leave timer.
By default, the setting of the leaveall timer is 1000 centiseconds (that is, 10
seconds).
A leaveall timer starts upon the start of a GARP application entity. When this timer
expires, the entity sends a LeaveAll message so that other entities can re-register
its attribute information and starts another leaveall timer at the same time.
command to set the leaveall timer of GARP.
command to restore the default. This may
413
Upper limit
Not greater than half of the
join timer setting
Less than half of the leave
timer setting
Less than the leaveall timer
setting
32765 centiseconds