Example
sdlc timer poll
Syntax
View
Parameter
Description
Example
sdlc window
Syntax
View
Parameter
Description
Use the
undo sdlc timer lifetime
By default, the secondary-station acknowledgment waiting time is 500
milliseconds.
# Set the secondary-station acknowledgment waiting time to 1,000 milliseconds
on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc timer lifetime 1000
sdlc timer poll mseconds
undo sdlc timer poll
Synchronous serial interface view
mseconds: SDLC polling interval in milliseconds. The effective range is 1 to 10,000.
Use the
sdlc timer poll
the amount of time the primary station waits between polling two secondary
stations.
Use the
undo sdlc timer poll
By default, SDLC polling interval is 1,000 milliseconds.
# Set the SDLC polling interval to 200 milliseconds on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc timer poll 200
sdlc window length
undo sdlc window
Synchronous serial interface view
length: The maximum number of consecutive frames the device can send before
receiving an acknowledgement from the peer, in the range of 1 to 7.
Use the
sdlc window
consecutive frames the device can send before receiving an acknowledgement
from the peer.
command to restore the default setting.
command to configure the SDLC polling interval, namely
command to restore the default setting.
command to configure the maximum number of
369