X25 Ignore Called-Address; X25 Ignore Calling-Address - H3C MSR 20-20 Command Reference Manual

446 C 26: LAPB
HAPTER
Example

x25 ignore called-address

Syntax
View
Parameter
Description
Related command:
Example

x25 ignore calling-address

Syntax
View
Parameter
X.25 C C
AND ONFIGURATION OMMANDS
# Create hunt group hg1 which uses cyclic selection policy.
<Sysname> system-view
[Sysname] x25 hunt-group hg1 round-robin
[Sysname-hg-hg1]
x25 ignore called-address
undo x25 ignore called-address
Interface view
None
Use the
x25 ignore called-address
address of the called DTE when X.25 initiates calls.
Use the
undo x25 ignore called-address
By default, this function is disabled.
According to X.25, the calling request packet must carry the address. However, on
some occasions, the X.25 calling request does not have to carry the called/calling
DTE address in a specific network environment or as is required by the application.
This command enables users to specify whether the call request packet sent by
X.25 in the device carries the called DTE address.
x25 response called-address, x25 response calling-address, x25 ignore
calling-address.
# Specify the call request packet from the X.25 interface Serial 2/0 not to carry the
called DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 ignore called-address
x25 ignore calling-address
undo x25 ignore calling-address
Interface view
None
command to enable it to ignore the X.121
command to disable this function.