Fr Dlci-Switch - H3C MSR 20-20 Command Reference Manual

Example

fr dlci-switch

Syntax
View
Parameter
Description
Related command:
Example
Use the command to cancel the configuration.
undo fr dlci
When the frame relay interface type is DCE or NNI, it is necessary to manually
configure virtual circuit for interface (either main interface or subinterface). When
the frame relay interface type is DTE, if the interface is main interface, the system
will automatically configure the virtual circuit according to the peer device.
The virtual circuit number on the physical interface is unique.
# Assign a virtual circuit with DLCI 100 to frame relay interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] fr dlci 100
[Sysname-fr-dlci-Serial2/0-100]
fr dlci-switch in-dlci interface interface-type interface-number dlci out-dlci
undo fr dlci-switch in-dlci
Frame relay interface view, MFR interface view
in-dlci: DLCI in the packets received on the interface, in the range 16 to 1007.
interface interface-type interface-number: Specifies an interface by its type and
number.
dlci out-dlci: DLCI in the sent packets. It is in the range 16 to 1007.
Use the
fr dlci-switch
switching.
Use the
undo fr dlci-switch
PVC switching.
By default, no static route is configured for frame relay PVC switching.
Before the static route of frame relay PVC is configured, it is necessary to enable
the frame relay PVC switching first by using the fr switching command.
The default type of the forwarding interface can be frame relay or MFR. You can
however specify a tunnel interface for forwarding, if one has been configured,
thus transmitting frame relay packets over IP networks.
fr switching.
# Configure a static route, allowing the packets on the link with DLCI of 100 on
Serial 2/0 to be forwarded over the link with DLCI of 200 on interface Serial 2/1.
command to configure a static route for frame relay PVC
command to delete a static route for frame relay
387