X25 Local-Cug - H3C MSR 20-20 Command Reference Manual

Description
Related command:
Example

x25 local-cug

Syntax
View
Parameter
Description
Use the
x25 ignore calling-address
address of the calling DTE when X.25 initiates calls.
Use the
undo x25 ignore calling-address
By default, this function is disabled.
According to X.25, the calling request packet must carry the address. However, on
some occasions, the X.25 calling request does not have to carry the called/calling
DTE address in a specific network environment or as is required by the application.
This command enables users to specify whether the call request packet sent by
X.25 in the device carries the calling DTE address.
x25 response called-address, x25 response calling-address, x25 ignore
called-address.
# Specify the call request packet from the X.25 interface Serial 2/0 not to carry the
calling DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 ignore calling-address
x25 local-cug local-cug-number network-cug network-cug-number [ no-incoming |
no-outgoing | preferential ]*
undo x25 local-cug cug-number
Interface view
local-cug-number: Number of local cug.
network-cug-number: Number of network cug.
no-incoming: Suppresses incoming calls.
no-outgoing: Suppresses outgoing calls.
preferential: Specifies the preference rule.
Use the
x25 local-cug
network CUG and define its suppression rule.
Use the
undo x25 local-cug
to network CUG.
The command is disabled by default.
CUG map is the exchange relationship between local (DTE device) and network
(X.25 network) CUG numbers when the device is processing CUG calls. For
command to enable it to ignore the X.121
command to disable this function.
command to configure mapping from local CUG to
command to remove the mapping from local CUG
447