Sdlc Mac-Map Remote - H3C MSR 20-20 Command Reference Manual

362 C 21: B
HAPTER ASIC
Example

sdlc mac-map remote

Syntax
View
Parameter
Description
DLS C C
W ONFIGURATION OMMANDS
Use the undo sdlc mac-map local
virtual MAC address.
By default, no SDLC virtual MAC address is configured.
Initially designed for LLC2 protocols, DLSw establishes mappings with virtual
circuits through MAC addresses. Therefore, a MAC address must be specified for
an SDLC virtual circuit so that SDLC frames can be forwarded. This command is
used to assign the current interface a virtual MAC address, which will serve as the
source MAC address during the conversion of SDLC frames to LLC2 frames.
n
Note that the sixth byte of the MAC address should be set to 0x00. The system will
combine the first five bytes of this virtual MAC address with the SDLC address into
a new MAC address, which will serve as the source MAC address in SDLC-to-LLC2
frame format conversion.
# Set the SDLC virtual MAC address to 0000-e81c-b600 on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc mac-map local 0000-e81c-b600
sdlc mac-map remote mac-addr sdlc-addr
undo sdlc mac-map remote mac-addr sdlc-addr
Synchronous serial interface view
mac-addr: MAC address of the SDLC peer to be configured.
sdlc-addr: SDLC address of the SDLC peer to be configured, in the range of 0x01
to 0xFE.
Use the
sdlc mac-map remote
Use the undo sdlc mac-map remote
By default, the synchronous serial interface has no remote peer.
This command is used to specify the MAC address of the corresponding peer end
for an SDLC virtual circuit so as to provide the destination MAC address for
SDLC-to-LLC2 frame conversion. In DLSw configuration, a peer should be
configured for each SDLC address. The MAC address of the peer should be the
MAC address of the remote SNA device (physical address in the Ethernet or Token
Ring format), or the compound MAC address obtained from SDLC virtual MAC
address of the peer end and the SDLC address of the local end.
In this configuration, pay attention to the difference in bit order between token
ring address and an Ethernet address:
command to delete the configured SDLC
command to configure an SDLC peer.
command to delete an SDLC peer.