Ipv6 Nd Ra Halt - H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
Description
Use the ipv6 nd nud reachable-time command to configure the neighbor reachable
time on an interface. This time value serves as not only the neighbor reachable time on
the local interface, but also the value of the Reachable Timer field in RA messages sent
by the local interface.
Use the undo ipv6 nd nud reachable-time command to restore the default neighbor
reachable time and to specify the value of the Reachable Timer field in RA messages
as 0 so that the number of hops is determined by the host itself, but not specified by the
device.
By default, the neighbor reachable time on the local interface is 30,000 milliseconds
and the Reachable Timer field in RA messages is 0.
Examples
# Set the neighbor reachable time on VLAN-interface 100 to 10,000 milliseconds.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd nud reachable-time 10000

1.1.29 ipv6 nd ra halt

Syntax
ipv6 nd ra halt
undo ipv6 nd ra halt
View
Interface view
Parameters
None
Description
Use the ipv6 nd ra halt command to suppress RA messages.
Use the undo ipv6 nd ra halt command to disable the RA message suppression.
By default, RA messages are suppressed.
Examples
# Suppress RA messages on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd ra halt
Chapter 1 IPv6 Basics Configuration Commands
1-32