Sdlc Enable Dlsw; Sdlc Mac-Map Local - H3C MSR 20-20 Command Reference Manual

Example

sdlc enable dlsw

Syntax
View
Parameter
Description
Example

sdlc mac-map local

Syntax
View
Parameter
Description
# Set the secondary SDLC station address to 0x05 on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] sdlc controller 05
sdlc enable dlsw
undo sdlc enable dlsw
Synchronous serial interface view
None
Use the
sdlc enable dlsw
synchronous serial interface.
Use the undo sdlc enable dlsw
current synchronous serial interface.
By default, DLSw forwarding is not enabled on the serial interface.
Before enabling DLSw forwarding on the serial interface, enable SDLC as the link
layer protocol on the interface. With DLSw forwarding enabled on the SDLC
interface, all local SNA devices connected to the interface will be able to
communicate with the remote device through DLSw.
# Enable DLSw forwarding on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol sdlc
[Sysname-Serial2/0] sdlc enable dlsw
sdlc mac-map local mac-address
undo sdlc mac-map local
Synchronous serial interface view
mac-address: Virtual MAC address of SDLC.
Use the
sdlc mac-map local
address.
command to enable DLSw forwarding on the current
command to disable DLSw forwarding on the
command to configure an SDLC virtual MAC
361