Reset Fr Pvc; Timer Hold - H3C MSR 20-20 Command Reference Manual

408 C 22: F
HAPTER RAME
Example

reset fr pvc

Syntax
View
Parameter
Description
Example

timer hold

Syntax
View
Parameter
Description
Related command:
Example
R C C
ELAY ONFIGURATION OMMANDS
# Clear all the frame relay dynamic address maps.
<Sysname> reset fr inarp
reset fr pvc interface serial interface-number [ dlci dlci-number ]
User view
interface-number: Interface number.
dlci dlci-number: DLCI assigned to an FR interface. The dlci-number argument is in
the range 16 to 1007. Note that DLCI 0 through 15 and 1008 through 1023 are
reserved for special use and are thus unavailable.
Use the
reset fr pvc
# Clear PVC statistics on Serial 2/0.
<Sysname> reset fr pvc interface serial 2/0
timer hold seconds
undo timer hold
Interface view
seconds: Value of T391 parameter at DTE side, which ranges from 0 to 32767 in
seconds. 0 indicates that the LMI protocol is disabled.
Use the
timer hold
Use the undo timer hold
By default, the parameter is 10 seconds.
The parameter is a time variable that defines the interval of Status-Enquiry packet
sent by DTE.
fr lmi t392dce.
# Configure that frame relay interface Serial 2/0 to operate in DTE mode, and set
the value of T391 parameter to 15 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
command to clear the statistics on a PVC.
command to configure T391 parameter at the DTE side.
command to restore the default.