H3C MSR 20-20 Command Reference Manual page 449

Table 66 Description on the attributes or user facilities of X.25 address mapping
Option
broadcast
closed-user-group group
number
compress
encapsulation-type
idle-timer minutes
no-callin
no-callout
packet-size input-size
output-size
reverse-charge-accept
reverse-charge-request
roa-list roa-name
send-delay delay-time
threshold input-value
output-value
vc-per-map count
window-size
input-window-size
output-window-size
Description Use the
X.121 address.
Use the
By default, no address mapping is configured.
Since X.25 protocol can multiplex multiple logical virtual circuits on a physical
interface, you need to manually specify the mapping relation between all network
addresses and X.121 addresses.
Once you have specified an address mapping, its contents (including protocol
address, X.121 address and all options) cannot be changed. To make
Description
Sends broadcasts of network protocol and multicasts of IP to
the destination. This option provides support for some routing
protocols (such as Routing Information Protocol).
Specifies a closed user group (CUG) number for the X.25
interface, in the range 0 to 9999.
Compresses X.25 payloads.
Encapsulation type, with nonstandard, ietf, multi-protocol
and snap available.
Maximum idle time for the VC associated with the address
mapping. 0 means that the idle time is infinite.
Disables accepting calls to the address mapping.
Disables calls originating from the address mapping.
Carries out maximum packet size negotiation when initiating
calls from the mapping. It needs two parameters: maximum
input packet size and maximum output packet size, which must
range from 16 to 4096 bytes, and must be the integer power of
2.
If a call initiated by the address mapping carries reverse
charging request, to accept the call, this option must be
configured in the address mapping.
Specifies calls from the address mapping to carry reverse
charging requests
Specifies an ROA list name for the X.25 interface. The roa name
is a string of 1 to 19 characters.
Carries out the maximum network transmission delay
negotiation when initiating calls from the mapping. The delay
time is in the range 0 to 65534 ms.
Specifies threshold values when initiating throughput
negotiation with the peer from the mapping. The values of
input/output can only be 75, 150, 300, 600, 1200, 2400, 4800,
9600, 19200, or 48000.
Maximum number of VCs associated with the address
mapping, in the range 1 to 8.
Carries out the window size negotiation with the peer when
initiating calls from the address mapping, including input
window size and output window size. When the modulo is 8,
the size is in the range 1 to 7; when the modulo is 128, it is in
the range 1 to 127.
x25 map command to set the address mapping between IP address and
command to delete a mapping.
undo x25 map
449