Display Interface Dialer - H3C MSR 20-20 Command Reference Manual

332 C 20: DCC C
HAPTER

display interface dialer

Syntax
View
Parameters
Description
Examples
C
ONFIGURATION OMMANDS
Table 31 Description on the fields of the display dialer command
Field
Enable
Idle
Wait-for-carrier
Total Channels
Free Channels
display interface dialer [ number ]
Any view
number : Dialer interface number.
Use the
display interface dialer
dialer interface. If you do not provide this argument, this command displays the
information about all the dialer interfaces.
# Display the information about all the dialer interfaces.
<H3C> display interface dialer
Dialer1 current state: UP
Line protocol current state: UP (spoofing)
Description: Dialer1 Interface
The Maximum Transmit Unit is 1500, Hold timer is 10(sec)
Internet protocol processing : disabled
Link layer protocol is PPP
LCP initial
Physical is Dialer, baudrate: 64000 bps
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Length)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Table 32 Description on the fields of the display interface dialer command
Field
current state
Line protocol current state
Description
The Maximum Transmit Unit
Internet protocol processing
Link layer protocol is PPP
Description
Timer set by the dialer timer enable command
Timer set by the dialer timer idle command
Timer set by the dialer timer wait-carrier command
Total number of channels on the interface
Number of free channels
command to display the information about a
0 bytes/sec 0 packets/sec
0 bytes/sec 0 packets/sec
Description
Physical state of a dialer interface (up/down)
Data link layer protocol state of the dialer interface
(up/down)
Interface description
MTU of the dialer interface
Network layer protocol state of the dialer interface
(enabled/disabled)
Current data link layer protocol
0/50/0
0/500/0
0/75/0