Dialer Flow-Interval; Dialer Isdn-Leased (Physical Interface View) - H3C MSR 20-20 Command Reference Manual

320 C 20: DCC C
HAPTER
Related command:
Example

dialer flow-interval

Syntax
View
Parameter
Description
Related command:
Example

dialer isdn-leased (physical interface view)

Syntax
View
Parameter
C
ONFIGURATION OMMANDS
If you perform the dialer enable-circular command or its undo form on a
non-dial interface, do the same on the interface to recover it.
dialer circular-group.
# Enable C-DCC on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] dialer enable-circular
dialer flow-interval interval
undo dialer flow-interval
System view
interval: Traffic statistics interval, in the range 1 to 1500 seconds.
Use the
dialer flow-interval
for DCC.
Use the undo dialer flow-interval
By default, the traffic statistics interval for DCC is 20 seconds.
This command is only useful for traffic-triggered dial in DCC. For example, when
using traffic-triggered MP link bundling with DCC, you may need to configure
DCC to send traffic statistics about dialup links at certain intervals to MP.
dialer threshold.
# Set traffic statistics interval to three seconds for DCC.
<Sysname> system-view
[Sysname] dialer flow-interval 3
dialer isdn-leased number
undo dialer isdn-leased number
Dial interface (Physical interface) view
number: Number of the ISDN B channel for leased line connection. It ranges from
0 to 1 for a BRI interface, and 0 to 30 (with 15 excluded for the control channel)
command to configure the traffic statistics interval
command to restore the default.