Dlsw Bridge-Set; Dlsw Enable - H3C MSR 20-20 Command Reference Manual

342 C 21: B
HAPTER ASIC

dlsw bridge-set

Syntax
View
Parameter
Description
Example

dlsw enable

Syntax
View
Parameter
DLS C C
W ONFIGURATION OMMANDS
Table 37 Description on the fields of the display llc2 command
Field
Role
State
dlsw bridge-set bridge-set
undo dlsw bridge-set bridge-set
System view
bridge-set: ID of the bridge set to be mapped to DLSw, in the range of 1 to 63.
Use the
dlsw bridge-set
Use the
undo dlsw bridge-set
specified bridge set and DLSw.
By default, no bridge set is mapped to DLSw.
To enable forwarding frames of a bridge set to the remote end over a TCP
connection, the local bridge set needs to be mapped to DLSw through this
command. This command can be used repeated to map multiple bridge sets to
DLSw.
For details about bridge set configuration, refer to "Bridging Configuration
Commands" on page 549.
# Map the bridge set by the ID of 20 connected to DLSw.
<Sysname> system-view
[Sysname] bridge enable
[Sysname] bridge 20 enable
[Sysname] dlsw bridge-set 20
dlsw enable
undo dlsw enable
System view
None
Description
Local role of LLC2 circuit
primary" represents the end that initiated the circuit
■
secondary" represents the end accepted the circuit connection
■
State of the LLC2 circuit
command to map the specified bridge set to DLSw.
command to remove mapping between the