Display Dialer - H3C MSR 20-20 Command Reference Manual

Related command:
Example

display dialer

Syntax
View
Parameter
Description
Example
resetting the idle-timeout timer if a link is present, or drops it without
originating calls for link setup if no link is present.
For DCC to send packets normally, you must configure a dial ACL and associate it
with the concerned dial interface (physical or dialer) by using the dialer-group
command.
If no dial ACL is configured for the dialer access group associated with a dial
interface, DCC will drop received packets on the interface as uninteresting ones.
dialer-group.
# Configure Dialer-rule1 and associate it with interface Serial 2/0.
<Sysname> system-view
[Sysname] dialer-rule 1 ip permit
[Sysname] interface serial 2/0
[Sysname-Serial2/0] dialer-group 1
display dialer [ interface interface-type interface-number ]
Any view
interface interface-type interface-number: Specifies an interface by its type and
number.
Use the
display dialer
DCC dial interfaces.
# Display information about all DCC dial interfaces.
<Sysname> display dialer
Dialer0 - dialer type = Dialer
Dialer Route:
NextHop_address
Dialer number
Dialer Timers(Secs):
Autodial:300
Idle:120 Wait-for-Carrier:60
Total Channels:1
Table 31 Description on the fields of the display dialer command
Field
dialer type
NextHop address
Dialer Number
Dialer Timers(Secs)
Auto-dial
Compete
command to display information about the specified or all
Dialer_Numbers
003
Compete:20 Enable:5
Free Channels:1
Description
Type of dial interface, dialer or physical
Remote address associated with a dialer route on the interface
Dial string for the remote IP address
DCC timers
Timer set by the dialer timer autodial command
Timer set by the dialer timer compete command
331