Dlsw Local - H3C MSR 20-20 Command Reference Manual

344 C 21: B
HAPTER ASIC

dlsw local

Syntax
View
Parameter
Description
DLS C C
W ONFIGURATION OMMANDS
dlsw local ip-address [ init-window init-window-size | keepalive keepalive-interval |
max-frame max-frame-size | max-window max-window-size | permit-dynamic |
vendor-id vendor-id ] *
undo dlsw local ip-address [ init-window | keepalive | max-frame | max-window |
permit-dynamic ] *
System view
ip-address: IP address of the local peer to be created. This IP address must be
reachable.
init-window-size: Initial local window size, in the range of 1 to 2,000. The default
is 40 (frames).
keepalive-interval: Interval between keepalive messages, in seconds. The effective
range is 0 to 1,200, and the default is 30 seconds. A value of 0 indicates that no
keepalive message will be sent.
max-frame-size: Maximum frame size in bytes. Effective values include 516, 1,470,
1,500, 2,052, 4,472, 8,144, 11,407, 11,454, and 17,800, and the default is 1,500
bytes.
max-window-size: Maximum local window size, in the range of 1 to 2,000. The
default is 50 (frames).
permit-dynamic: Permits non-peer routers to initiate connections to establish
peering relationships dynamically with this router. It is not required to configure a
remote peer for a router established as a local peer with this keyword included in
the command.
vendor-id: DLSw vendor identifier, in the range of 00.00.00 to ff.ff.ff. The default
is 00.e0.fc.
Use the
dlsw local
Use the
undo dlsw local
DLSw peer.
Use the
undo dlsw local
max-window | permit-dynamic } * command to restore the default parameters.
Deleting a local DLSw peer will automatically delete all its remote DLSw peers.
Establishing a TCP connection is the first step in establishing a DLSw circuit. To
establish a TCP connection, you need to specify the IP addresses of both end
systems across the TCP connection. By configuring a local DLSw peer, you specify
the IP address of the local end across the TCP connection. This is required before a
router can initiate or accept a TCP connection request. A router can only have one
local peer.
command to create a local DLSw peer.
ip-address command to remove the specified local
ip-address { init-window | keepalive | max-frame |