Interface Dialer - H3C MSR 20-20 Command Reference Manual

interface dialer

Syntax
View
Parameter
Description
Table 32 Description on the fields of the display interface dialer command
Field
LCP initial
Physical is Dialer
Output queue : (Urgent queuing :
Size/Length/Discards)
Output queue : (Protocol queuing
: Length)
Output queue : (FIFO queuing :
Size/Length/Discards)
Last 300 seconds input: 0
bytes/sec, 0 packets/sec
Last 300 seconds output: 0
bytes/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops Statistics on the packets sent through the interface
interface dialer number
undo interface dialer number
System view
number: Dialer interface number, in the range 0 to 1023.
Use the
interface dialer
equals creating a dialer circular group.
Use the undo interface dialer
By default, no dialer interface is created.
The dialer interface has a fixed baudrate of 64,000 bps.
In C-DCC, you may assign multiple physical interfaces to a dialer interface to
inherit the attributes of this dialer interface by assigning them to the dialer circular
group for the dialer interface with the dialer circular-group command. This is
efficient where calling multiple destinations simultaneously is desired, because
instead of configuring individual physical interfaces, you only need to configure
multiple dialer routes on the dialer interface.
In RS-DCC, any dialer interface can use the services provided by multiple physical
interfaces, and individual physical interfaces can provide services for multiple dialer
interfaces at the same time. Therefore, authentication must be configured on
these physical interfaces, so as to use the username of a dial-in party to locate the
corresponding dialer interface for the call. In this mode, physical interfaces and
dialer interfaces are dynamically bound. Furthermore, a dialer interface can only
call a destination address as specified in the dialer number command.
Description
LCP is initialized.
The physical interface is a dialer interface.
Statistics on the packets in the urgent output queue
Statistics on the packets in the protocol output queue
Statistics on the packets in the FIFO output queue
Input interface data rate during the latest 300 seconds
Output interface data rate during the latest 300 seconds
Statistics on the packets reaching the interface
command to create a dialer interface. In C-DCC, this
command to remove a dialer interface.
333