Display Dlsw Circuits; Code Nrzi - H3C MSR 20-20 Command Reference Manual

21

code nrzi

Syntax
View
Parameter
Description
Example

display dlsw circuits

Syntax
View
Parameter
B DLS
ASIC
C
OMMANDS
code nrzi
undo code
Synchronous serial interface view
None
Use the command to configure the synchronous serial interface to use
code nrzi
NRZI encoding.
Use the command to configure the synchronous serial interface to
undo code
use NRZ encoding.
By default, the NRZ encoding scheme is used on the synchronous serial interface.
There are two encoding schemes, NRZI and NRZ, for synchronous serial interface.
The NRZ encoding scheme is generally used for synchronous serial interfaces of
routers. The serial interfaces of some SNA devices, however, use NRZI encoding.
Therefore, the encoding scheme of routers should be changed according to the
encoding schemes used on the connected devices.
# Configure Serial 1/0 to use NRZI encoding.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] code nrzi
display dlsw circuits [ circuit-id ] [ verbose ]
Any view
circuit-id: Specifies the ID of a DLSw virtual circuit, in the range of 0 to 0xFFFFFFFF.
verbose: Displays the detailed information of the virtual circuits.
C
W ONFIGURATION