Dialer Disconnect; Dialer Enable-Circular - H3C MSR 20-20 Command Reference Manual

dialer disconnect

Syntax
View
Parameter
Description
Example

dialer enable-circular

Syntax
View
Parameter
Description
[Sysname-Serial2/0] dialer circular-group 1
[Sysname-Serial2/0] quit
[Sysname] interface serial 2/1
[Sysname-Serial2/1] dialer circular-group 1
dialer disconnect [ interface interface-type interface-number ]
Any view
interface interface-type interface-number: Specifies an interface by its type and
number.
Use the
dialer disconnect
all dialup links if no interface is specified.
# Clear the dialup link on interface Dialer0.
<Sysname> dialer disconnect interface dialer0
dialer enable-circular
undo dialer enable-circular
Dial interface (physical or dialer) view
None
Use the
dialer enable-circular
(C-DCC).
Use the
undo dialer enable-circular
By default, C-DCC is enabled on ISDN BRI and PRI interfaces but disabled on other
interfaces.
You need to enable C-DCC before you can use it.
To use resource-shared DCC (RS-DCC) on a dialer interface, you need to configure
the dialer user command and the dialer bundle command on the dialer
interface and assign physical interfaces to the dialer bundle with the dialer
bundle-member command.
After you disable C-DCC, the system clears all configurations on dial interfaces. To
make them recover, you need to shut down and then bring up them by
performing the shutdown command and then the undo shutdown command.
command to clear the dialup link on an interface or
command to enable circular dial control center
command to disable C-DCC.
319