Introduction; Clear Ipv6 Neighbors; Ipv6 Address - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IPv6 Commands

Introduction

This chapter lists, in alphabetical order, the IPv6 commands used by the AlliedwarePlus™
Operating System.

clear ipv6 neighbors

clear ipv6 neighbors Command
Use this command to clear all dynamic IPv6 neighbor entries.
Syntax
clear ipv6 route kernel
Privileged Exec mode
Mode
Examples

ipv6 address

ipv6 address Command
Use this command to set the IPv6 address of an interface. Use the no form of this command to
remove the address assignment.
Syntax
ipv6 address <ipv6-addr/prefix-length>
no ipv6 address <ipv6-addr/prefix-length>
Parameter
ipv6 address
<ipv6-addr/prefix-length>
Interface mode
Mode
To assign the IPv6 address to the interface VLAN 2, use the following commands:
Examples
awplus(config-if)#
show running-config
Validation
Commands show ipv6 interface brief
show ipv6 route
25.2
New vs_531 %flag
awplus# clear ipv6 neighbors
New vs_531 %flag
awplus# configure terminal
awplus(config)# interface VLAN2
ipv6 address 2001:0DB8::a2/64
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6 Commands This new command clears all dynamic IPv6 neighbor entries.
IPv6 Commands This new command will set the IPv6 address of an interface.
Description
Specifies the IPv6 address using the format shown
below.
Specifies the IPv6 address to be set.
The IPv6 address uses the format X:X::X:X/Prefix-
Length; where prefix length represents a decimal
number between 0 and 128.
C613-50007-01 REV B