Show Port-Security Intrusion - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

show port-security intrusion

Shows the intrusion list. If the port is not give, entire intrusion table is shown.
Syntax
show port-security intrusion [interface <port>]
Parameter
show
port-security
intrusion
interface
<port>
Exec mode and Privileged Exec mode
Mode
To see the intrusion list on port1.0.1, use command:
Example
Figure 15-9: Example output from the show port-security intrusion command for port 1.0.1
Output
15.36
Description
Show running system information
Port Security
Display intrusion list
Specify a port
The port to display information about. The port may be a switch
port (e.g., port1.1.4), a static channel group (e.g., sa3), or an LACP
channel group (e.g., po4).
awplus# show port-security intrusion interface port1.0.1
Port Security Intrusion List
Interface: port1.0.1 -3 intrusion(s) detected
11-22-33-44-55-04 11-22-33-44-55-06 11-22-33-44-55-08
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B