Interface Commands
Introduction
This chapter provides an alphabetical reference of commands used to configure and display
interfaces.
description
This command adds a description to a specific port or interface.
Syntax
description <description>
Parameter
<description>
Interface mode
Mode
The following example uses this command to describe the device that a switch port is
Examples
connected to.
12.2
Description
Text describing the specific interface.
awplus(config)#
interface port1.0.2
awplus(config-if)#
description Boardroom PC
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus
Operating System - Software Version 5.3.1
C613-50007-01 REV B