Show Etherchannel - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show etherchannel

Use this command to display information about an LACP etherchannel specified by the
channel-group number.
The command output also shows the thrash limiting status. If thrash limiting is detected and the
thrash limiting parameter of the
disable, the output will also show the VLANs on which thrashing is detected.
To modify the lines displayed, use the | (output modifier token); to save the output to a file,
use the > output redirection token.
Syntax
show etherchannel [<1-65535>]
Exec and Privileged Exec mode
Mode
Example
Figure 21-3: Example output from the show etherchannel command
Output
C613-50007-01 REV B
awplus# show etherchannel 5
% Lacp Aggregator: po1
Thrash-limiting
Status Vlan Thrashing Detected, Action vlan-disable 60(s)
Thrashing Vlans 1 2 3 4 5
% Member:
port1.0.4
port1.0.8
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
thrash-limiting command on page 15.44
Link Aggregation Commands
is set to vlan
21.9