Introduction; Connecting The Grounding Wire With The Grounding Terminal" On - Allied Telesis SwitchBlade x908 GEN2 Installation Manual

Chapter 5: Wiring the SBxPWRSYS1-80 DC Power Supply

Introduction

120
The procedures in this chapter explain how to attach the ground and
power wires to the SBxPWRSYS1-80 DC Power Supplies. If you have not
installed the power supplies, refer to "Installing SBxPWRSYS1-80 DC
Power Supplies" on page 105 for instructions.
The power supply unit has a ground connection and positive and negative
DC terminals. You may install the ground and power lead wires with the
terminal lugs that come with the unit or with bare wire. The wire
requirements are slightly different for terminal installation versus bare wire
installation. Here are the wire requirements if you are using the terminals
that come with the power supply:

Two 8 AWG stranded power wires (not provided)
 One 10 AWG stranded grounding wire (not provided)
Here are the wire requirements for bare wire installation:

Two 8 AWG solid or stranded power wires (not provided)

One 10 AWG solid or stranded grounding wire (not provided)
Here is a list of the required tools:
 Crimping tool (not provided)

8 mm wrench (not provided)

#1, #2, and #3 Phillips-head screwdrivers (not provided)

#3 Phillips-head 30 to 40 inch-lbs Phillips-head torque screwdriver
(optional - not provided)
Here are the wiring procedures for the SBxPWRSYS1-80 DC Power
Supply:
 "Choosing a Method for Attaching the Grounding Wire" on page 122


"Connecting the Grounding Wire with the Grounding Terminal" on

page 123

"Connecting the Grounding Wire with Bare Wire" on page 128

"Introduction to Attaching the Power Wires" on page 131
 "Connecting the DC Power Wires with the Straight Terminals" on
page 132
 "Connecting the DC Power Wires with the Right Angle Terminals" on
page 139
 "Connecting Bare DC Power Wires" on page 145