Show Debugging Rip; Show Ip Protocols Rip - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIP Commands

show debugging rip

Use this command to display the RIP debugging status for these debugging options: nsm
debugging, RIP event debugging, RIP packet debugging and RIP nsm debugging.
To modify the lines displayed, use the | (output modifier token); to save the output to a file
use the > output redirection token.
Syntax
show debugging rip
Privileged Exec mode
Mode
Use this command to display the debug status of RIP.
Usage
Example
awplus#

show ip protocols rip

Use this command to display RIP process parameters and statistics.
To modify the lines displayed, use the | (output modifier token); to save the output to a file
use the > output redirection token.
Syntax
show ip protocols rip
Privileged Exec mode and Exec mode
Mode
Example
awplus#
This is an example of the output from the show ip protocols rip command:
Output
32.32
show debugging rip
show ip protocols rip
awplus#show ip protocols rip
Routing Protocol is "rip"
Sending updates every 30 seconds with +/-50%, next due in 12
seconds
Timeout after 180 seconds, garbage collect after 120 seconds
Outgoing update filter list for all interface is not set
Incoming update filter list for all interface is not set
Default redistribution metric is 1
Redistributing: connected static
Default version control: send version 2, receive version 2
Interface Send
VLAN25 2
Routing for Networks:
10.10.0.0/24
Routing Information Sources:
Gateway BadPackets BadRoutes
Distance: (default is 120
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Recv Key-chain
2
Distance Last Update
C613-50007-01 REV B