Duplex - Allied Telesis SwitchBlade x908 Series Software Reference Manual

duplex

This command changes the duplex mode for the specified port.
By default, ports auto-negotiate duplex mode (except for 100Base-FX ports which do not
support auto-negotiation, so default to full duplex mode).
To see the currently-negotiated duplex mode for ports whose links are up, use the command
show
command
Syntax duplex {auto|full|half}
Parameter
auto
full
half
Interface mode
Mode
Switch ports in a static or dynamic (LACP) channel group must have the same port speed and
Usage
be in full duplex mode. Once switch ports have been aggregated into a channel group, you can
set the duplex mode of all the switch ports in the channel group by applying this command to
the channel group.
To specify full duplex, enter the command:
Examples
To specify half duplex, enter the commando
To auto-negotiate duplex mode, enter the command:
speed
Related Commands
show interface
C613-50007-01 REV B
interface. To see the configured duplex mode (when different from the default), use the
show running-config.
Description
Auto-negotiate duplex mode
Operate in full duplex mode only
Operate in half duplex mode only
awplus(config-if)# duplex full
awplus(config-if)# duplex half
awplus(config-if)# duplex auto
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands
15.7