Copy Current-Software; Copy Debug - Allied Telesis SwitchBlade x908 Series Software Reference Manual

File Management Commands

copy current-software

This command copies the AlliedWare Plus
a destination file. Specify whether the destination is Flash or Card when saving the software to
the local file system.
Syntax
copy current-software <destination-url>
Parameter
<destination-url>
Privileged Exec mode
Mode
To copy the current software install the working directory with the name
Examples
my-release.rel, use the command:
boot system
Related Commands
show boot

copy debug

This command copies a specified debug file to a destination file. Specify whether the destination
is Flash or Card when saving the software to the local file system.
Syntax
copy debug {<destination-url>|card|debug|flash|nvs|scp|tftp}
Parameter
<destination-url>
<source-url>
Privileged Exec mode
Mode
To copy debug output to SD card with a filename my-debug, use the following command:
Examples
awplus#copy debug card:mydebug
Enter source file name []:
delete debug
Related Commands
move debug
7.6
Description
The URL where you would like the current running-release saved.
This command creates a file if no file exists with the specified
filename. If a file already exists, then the CLI prompts you before
overwriting the file. See
page 7.3
awplus#copy current-software my-release.rel
{<source-url>|card|debug|flash|nvs|scp|tftp}
Description
The URL where you would like the debug output saved. See
Syntax and Keyword Usage" on page 7.3
The URL where the debug output originates. See
Keyword Usage" on page 7.3
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
TM
OS software that the device has booted from to
"URL Syntax and Keyword Usage" on
for valid URL syntax.
for valid URL syntax.
"URL
for valid URL syntax.
"URL Syntax and
C613-50007-01 REV B