Set Ipv6 Next-Hop - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Route Map Commands

set ipv6 next-hop

Use this command to set a next hop-address.
Use the no parameter with this command to delete an entry.
Syntax
set ipv6 next-hop {<ipv6-address-global>|local <ipv6-address>}
no set ipv6 next-hop [<ipv6-address-global>|local [<ipv6-address>]]
Parameter
<ipv6-address-global>
local
<ipv6-address>
Route-map mode
Mode
Use this command to set the next-hop IPv6 address to the routes.
Usage
This command is valid only for BGP.
Examples
awplus(config-route-map)#
awplus(config-route-map)#
39.30
Description
Specifies the IPv6 global address of next hop, entered in
the format X:X::X:X
Specifies that the address is local.
Specifies the IPv6 local address of next hop, entered in the
format X:X::X:X.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map rmap1 permit 3
set ipv6 next-hop local
fe80::203:47ff:fe97:66dc
no set ipv6 next-hop
C613-50007-01 REV B