Ipv6 Rip Split-Horizon - Allied Telesis SwitchBlade x908 Series Software Reference Manual

ipv6 rip split-horizon

ipv6 rip split-horizon Command
Use this command to perform the split-horizon action on the interface. The default is split-
horizon with poisoned reverse.
Use the no parameter with this command to disable this function.
Syntax
ipv6 rip split-horizon [poisoned]
no ipv6 rip split-horizon
Parameter
split-horizon
poisoned
Split-horizon with poisoned reverse is the default.
Default
Interface mode
Mode
Use this command to avoid including routes in updates sent to the same gateway from which
Usage
they were learned. Using the split horizon command omits routes learned from one
neighbor, in updates sent to that neighbor. Using the poisoned parameter with this command
includes such routes in updates, but sets their metrics to infinity. Thus, advertising that these
routes are not reachable.
Example
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
show running-config
Validation
Commands
C613-50007-01 REV B
New vs_531 %flag
Description
Required. Perform split-horizon without poisoned reverse
Optional. Performs split-horizon with poisoned reverse.
awplus# configure terminal
awplus(config)# interface vlan2
ipv6 rip split-horizon
awplus# configure terminal
awplus(config)# interface vlan2
ipv6 rip split-horizon poisoned
awplus# configure terminal
awplus(config)# interface vlan2
no ipv6 rip split-horizon
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIPng Commands Use this command to avoid including routes in updates sent to the same gateway from which they were learned.
RIPng Commands
34.7