BGP Commands
neighbor strict-capability-match
Use this command to close the BGP connection if the capabilities being advertised by the
switch do not exactly match the capabilities being advertised by the neighbor.
Use the no parameter with this command to disable this function
Syntax
neighbor <neighborid> strict-capability-match
no neighbor <neighborid> strict-capability-match
Parameter
<neighborid>
Router mode
Mode
Example
awplus(config-router)#
38.88
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
awplus#
configure terminal
awplus(config)#
router bgp 12
neighbor 10.10.10.10 strict-capability-match
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus
Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
Name of an existing peer-group. For information on how to
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
this parameter is used with a command, the command
applies on all peers in the specified group.
neighbor peer-group
38.75, and
38.79. When
C613-50007-01 REV B