Neighbor (Ipv) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor (IPv6)
neighbor (IPv6) Command
Use this command to specify a neighbor router.
Use the no parameter with this command to disable the specific router.
Syntax neighbor <ipv6-link-local-addr> <ifname>
no neighbor <ipv6-link-local-addr> <ifname>
Parameter
<ipv6-link-local-addr>
<ifname>
Router mode
Mode
Use this command to exchange non broadcast routing information. It can be used multiple
Usage
times for additional neighbors.
The
the neighbor command in conjunction with the
routing updates to specific neighbors
Example
awplus(config-router)#
awplus(config-router)#
passive-interface (IPv6)
Related Commands
C613-50007-01 REV B
New vs_531 %flag
passive-interface (IPv6) command disables sending routing updates on an interface. Use
awplus# configure terminal
awplus(config)# router ipv6 rip
neighbor de80::1 vlan2
awplus# configure terminal
awplus(config)# router ipv6 rip
no neighbor de80::1 vlan2
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIPng Commands Use this command to specify a neighbor router.
Description
Specify the link-local IPv6 address (in the format X:X::X:X) of a
neighboring router to exchange routing information with.
Name of the interface
passive-interface (IPv6)
.
RIPng Commands
command to send
34.9