Match Tag - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Route Map Commands

match tag

Use this command to add a tag match clause to a route map entry. Specify the route tag value
to match.
An OSPF route matches the route map if it has been tagged with the route map's tag value.
Routes can be tagged through OSPF commands or through another route map's set clause.
Each entry of a route map can only match against one tag in one match clause. If the route map
entry already has a tag match clause, entering this command replaces that match clause with
the new clause.
Use the no parameter to remove the tag match clause from the route map entry.
Syntax
match tag <0-4294967295>
no match tag [<0-4294967295>]
Route-map mode
Mode
This command is valid for OSPF routes only.
Usage
To add entry 10 to the route map called mymap1, which will process routes that are tagged
Examples
100, use the following commands:
awplus(config-route-map)#
match interface
Related Commands
match ip address
match ip next-hop
match route-type
route-map
set tag
show route-map
39.16
awplusc#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
onfigure terminal
route-map mymap1 permit 10
match tag 100
C613-50007-01 REV B