Service Terminal-Length; Show Privilege - Allied Telesis SwitchBlade x908 Series Software Reference Manual

service terminal-length

Use this command to specify the number of rows of output that the device will display before
pausing, for all console and VTY lines.
Use the no parameter to remove the length specified by this command. The default length will
apply unless you have changed the length for some or all lines by using the
page
Syntax service terminal-length <lines>
no service terminal-length <lines>
Parameter
terminal-length
<lines>
Global Configuration mode
Mode
This command overrides any lengths set by using the
Usage
mode.
To display 60 rows of text before pausing, use the command:
Example
awplus(config)#
service terminal-length
Related Commands
terminal length

show privilege

This command displays the current privilege level of the user, either 1 (limited access) or 15
(full access).
Syntax
show privilege
Exec mode and Privileged Exec mode.
Mode
Example
awplus#
Current privilege level is 15
C613-50007-01 REV B
5.6.
Description
Establish system-wide terminal length configuration.
<0-512>
Number of rows that the device will display before pausing.
awplus# configure terminal
service terminal-length 60
show privilege
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
User Access Commands
length command on
length command on page 5.6 in Line
5.11