Show Debugging Ospf - Allied Telesis SwitchBlade x908 Series Software Reference Manual

router-id
Use this command to specify a router ID for the OSPF process.
Use the no parameter with this command to force OSPF to use the previous OSPF router-id
behavior.
Syntax
router-id <ip_address>
no router-id
Parameter
<ip_address>
Router mode
Mode
Configure each router with a unique router-id. In an OSPF router process that has active
Usage
neighbors, a new router-id is used at the next reload or when you restart OSPF manually.
The following example shows a fixed router ID 10.10.10.60
Examples
awplus(config-router)#
show ip ospf
Related Commands

show debugging ospf

Use this command to display which OSPF debugging options are currently enabled.
To modify the lines displayed, use the | (output modifier token) ; to save the output to a file,
use the > output redirection token.
Syntax
show debugging ospf
Privileged Exec mode
Mode
To display which OSPF debugging options are currently enabled, use the command
Examples
C613-50007-01 REV B
Description
Specifies the router ID in IPv4 address format.
awplus#
awplus(config)#
awplus#show debugging ospf
OSPF debugging status:
OSPF packet Link State Update debugging is on
OSPF all events debugging is on
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
router ospf 100
router-id 10.10.10.60
OSPF Commands
36.55