Debug Ospf Lsa - Allied Telesis SwitchBlade x908 Series Software Reference Manual

OSPF Commands

debug ospf lsa

This command enables debugging options for OSPF Link State Advertisements (LSA)
troubleshooting. This displays information related to internal operations of LSAs.
To enable all debugging options, specify debug ospf lsa with no additional parameters.
The no and undebug form disables OSPF LSA debugging. Use this command without
parameters to disable all the options.
Syntax
debug ospf lsa [flooding] [generate] [install] [maxage] [refresh]
no debug ospf lsa [flooding] [generate] [install] [maxage] [refresh]
undebug ospf lsa [flooding] [generate] [install] [maxage] [refresh]
Parameter
flooding
generate
install
maxage
refresh
Privileged Exec mode and Global Configuration mode
Mode
Figure 36-1: Example output from the
Output
2002/05/09 14:08:11 OSPF: LSA[10.10.10.10:10.10.10.70]: instance(0x8139cd0)
created with Link State Update
2002/05/09 14:08:11 OSPF: RECV[LS-Upd]: From 10.10.10.70 via vlan5:10.10.10.50
(10.10.10.10 -> 224.0.0.5)
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: Begin send queue
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: # of LSAs 1, destination 224.0.0.5
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: End send queue
2002/05/09 14:12:33 OSPF: SEND[LS-Upd]: To 224.0.0.5 via vlan5:10.10.10.50
Examples
terminal monitor
Related Commands
36.18
Description
Displays LSA flooding.
Displays LSA generation.
Show LSA installation.
Shows maximum age of the LSA in seconds.
Displays LSA refresh.
awplus# undebug ospf lsa refresh
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
debug ospf lsa command
C613-50007-01 REV B