Setting Priority - Allied Telesis SwitchBlade x908 Series Software Reference Manual

OSPF Configuration
Switch 2
awplus#configure terminal
awplus(config)#router ospf 200
awplus(config-router)#network 10.10.10.0/24
area 0
Names of Commands Used
network
Validation Commands
show ip

Setting priority

This example shows the configuration for setting the priority for an interface. You can set a high
priority for an OSPF router to make it the Designated Router (DR). In this example, the OSPF
routers are Allied Telesis managed Layer 3 switches. Switch 3 is configured to have a priority of
10, which is higher than the default priority (default priority is 1) of Switch 1 and Switch 2;
making it the DR. In this example network the back-up DR would be Switch 2 as it has a higher
router ID than Switch 1.
35.4
area, router ospf
ospf, show ip ospf interface,
AS1
Area 0
port1.0.2
10.10.10.10/24
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Enter the Configure mode
Configure the Routing process and specify the Process
ID (200). The Process ID should be a unique positive
integer identifying the routing process. Note that the
process ID used on this switch is different to that used
on Switch 1. This is correct configuration as the process
ID is a value that is only used within a single OSPF router.
Therefore there is no requirement for the process IDs
used on one OSPF router to have any relationship with
the process IDs used on the other OSPF routers that it
interacts with.
Define the interface (10.10.10.0/24) on which
OSPF runs and associate the area ID (0) with the
interface.
show ip ospf neighbor,
Switch 2
10.10.10.11/24
port1.0.1
port1.0.1
10.10.10.13/24
Switch 1
show ip ospf route
Switch 3
Designated
Router
ospf_2
C613-50007-01 REV B