Log Host (Filter) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

log host (filter)

Creates a filter to select messages to be sent to a remote syslog server. Selection can be based
on the priority/severity of the message, the program that generated the message, the logging
facility used, a substring within the message or a combination of some or all of these.
The no log host command configures the device to no longer send log messages to a
remote syslog server. The IP address of the syslog server must be specified. All configuration
relating to this log target will be removed.
Syntax
log host <ip-address>
no log host <ip-address>
Parameter
log
host
<ip-address>
no
level
<level>
C613-50007-01 REV B
[level <level>]
[program <program-name>]
[facility <facility>]
[msgtext <text-string>]
[level <level>]
[program <program-name>]
[facility <facility>]
[msgtext <text-string>]
Description
Logging control
Send log messages to a remote syslog server
The IP address of a remote syslog server, entered in A.B.C.D format
Deletes the specified filter, so that corresponding messages are no longer
sent to the specified email address.
Filter messages by severity level.
The minimum severity of messages to send. The level can be specified as
one of the following numbers or level names, where 0 is the highest
severity and 7 is the lowest severity:
0|emergencies:
1|alerts
2|critical
3|errors
4|warnings
5|notices
6|informational
7|debugging
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
Logging Commands
10.23