Ip Ospf Resync-Timeout - Allied Telesis SwitchBlade x908 Series Software Reference Manual

ip ospf resync-timeout

Use this command to set the interval after which adjacency is reset if out-of-band
resynchronization has not occurred. The interval period starts from the time a restart signal is
received from a neighbor.
Use the no parameter with this command to return to the default value.
Syntax
ip ospf [<ip_address>] resync-timeout <1-65535>
no ip ospf [<ip_address>] resync-timeout
Parameter
<ip_address>
<1-65535>
Interface mode
Mode
The following example shows setting the OSPF resynchronization timeout value to 65 seconds
Examples
on the vlan2 interface.
C613-50007-01 REV B
Description
The IP address of the interface.
Specifies the resynchronization timeout value of the interface in seconds.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip ospf resync-timeout 65
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
OSPF Commands
36.39