Spanning-Tree Link-Type - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Spanning Tree Commands

spanning-tree link-type

Use this command to enable or disable point-to-point or shared link types on the switch port.
Use this command for RSTP or MSTP only.
Use the no parameter to return the port to the default link type.
Syntax spanning-tree link-type {point-to-point|shared}
no spanning-tree link-type
Parameter
shared
point-to-point
The default link type is point-to-point.
Default
Interface mode
Mode
You may want to set link type to shared if the port is connected to a hub with multiple
Usage
switches connected to it.
Examples
awplus(config-if)#
19.32
Description
Disable rapid transition.
Enable rapid transition.
awplus# configure terminal
awplus(config)# interface port1.1.3
spanning-tree link-type point-to-point
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B