Show Port-Security Interface - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show port-security interface

Shows the current configuration and the switch port status.
Syntax
show port-security interface <port>
Parameter
show
port-security
interface
<port>
Exec and Privileged Exec Mode
Mode
To see the port-security status on port1.0.1, use command:
Example
Figure 15-8: Example output from the show port-security interface command for port 1.0.1
Output
C613-50007-01 REV B
Description
Show running system information
Port Security
Interface
The port to display information about. The port may be a switch port
(e.g., port1.1.4), a static channel group (e.g., sa3), or an LACP channel
group (e.g., po4).
awplus#
Port Security configuration
Security Enabled
Port Status
Violation Mode
Aging
Maximum MAC Addresses
Current Learned Addresses
Lock Status
Security Violation
Last Violation Source
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show port-security interface port1.0.1
: YES
: ENABLED
: TRAP
: OFF
: 3
: 1
: UNLOCKED
Count : 0
Address: None
Switching Commands
15.35