Debug Ip Packet Interface - Allied Telesis SwitchBlade x908 Series Software Reference Manual

debug ip packet interface

The debug ip packet interface command enables IP packet debug and is controlled by the
terminal monitor command.
■
■
■
■
■
■
■
■
The no debug ip interface command disables the debug ip interface command.
Syntax
debug ip packet interface {<interface-name>|all}
no debug ip packet interface [<interface-name>]
Parameter
<interface-name>
all
<ip-address>
verbose
hex
arp
udp
tcp
icmp
Privileged Exec mode and Global Configuration mode
Mode
To turn on ARP packet debugging on VLAN 1, use the command:
Examples
To turn on all packet debugging on all interfaces on the switch, use the command:
To turn on TCP packet debugging on VLAN 1 and IP address 192.168.2.4 , use the command:
C613-50007-01 REV B
The required interface placeholder following the optional interface keyword can be
specified as either all or as a single layer 3 interface to show debugging for either all
interfaces or a single interface.
If the optional address keyword is specified then only packets with the specified IP
address as specified in the ip-address placeholder are shown in the output.
If the optional verbose keyword is specified then more of the packet is shown in the
output.
If an optional hex keyword is specified then the output for the packet is shown in hex.
If the optional arp keyword is specified then ARP packets are shown in the output.
If the optional udp keyword is specified then UDP packets are shown in the output.
If the optional tcp keyword is specified then TCP packets are shown in the output.
If the optional icmp keyword is specified then ICMP packets are shown in the output.
[address <ip-address>|verbose|hex|arp|udp|tcp|icmp]
Description
Specify a single layer 3 interface name (not a range of interfaces)
Specify all layer 3 interfaces on the switch.
Specify an IPv4 address, in the A.B.C.D format.
Specify verbose to output more of the IP packet.
Specify hex to output the IP packet in hexadecimal.
Specify arp to output ARP protocol packets.
Specify udp to output UDP protocol packets.
Specify tcp to output TCP protocol packets.
Specify icmp to output ICMP protocol packets.
awplus#
awplus#
awplus#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
debug ip packet interface vlan1 arp
debug ip packet interface all
debug ip packet interface vlan1 address
192.168.2.4 tcp
IP Addressing and Protocol Commands
23.5