Loop-Protection - Allied Telesis SwitchBlade x908 Series Software Reference Manual

loop-protection

loop-protection Command
Use this command to enable the Loop Protection - loop detection - feature, and configure the
detection mechanism parameters.
Syntax
loop-protection loop-detect [ldf-interval <period>] [ldf-rx-window
no loop-protection
Parameter
ldf-interval
<period>
ldf-rx-window
<frames>
no
Mode Global Configuration mode
no loop-protection
Default
Usage Use this command to enable the Loop Protection feature, and configure the detection
mechanism, and the detection mechanism parameters.
To enable the loop-detect mechanism, and generate loop-detect frames once every 5 seconds,
Example
use the command:
C613-50007-01 REV B
new vs_531 %flag
<frames>]
Description
The time (in seconds) between successive loop-detect frames being
sent.
A period between 5 and 600 seconds.
The default is 10 seconds.
The number of transmitted loop detection frames whose details are
held for comparing with frames arriving at the same port.
A value for the window size between 1 and 5 frames.
The default is 3 frames.
This variant of the command disables the loop protection feature.
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands This command enables the Loop Protection - loop detection - feature, and configures the detection mechanism parameters.
loop-protection loop-detect ldf-interval 5
Switching Commands
15.9