Ipv6 Nd Ra-Interval - Allied Telesis SwitchBlade x908 Series Software Reference Manual

The following example configures the switch to issue router advertisements on VLAN4, and
Example
advertises the address prefix of 2001:0DB8::/64.
awplus(config-if)#
ipv6 nd suppress-ra
Related Commands

ipv6 nd ra-interval

ipv6 nd ra-interval Command
Use this command to specify the interval between IPv6 Router Advertisements (RA)
transmissions.
Use no parameter with this command to reset the value to default.
Syntax
ipv6 nd ra-interval <seconds>
no ipv6 nd ra-interval <seconds>
Parameter
<
seconds
600 seconds.
Default
Interface mode
Mode
Advertisement flags will not be transmitted unless you have applied the
Usage
command on page 25.10
To set the advertisements interval on VLAN4 to be 60 seconds, use the following commands:
Example
awplus(config-if)#
awplus(config-if)#
ipv6 nd suppress-ra
Related Commands
ipv6 nd prefix
C613-50007-01 REV B
awplus# configure terminal
awplus(config)# interface vlan4
ipv6 nd prefix 2001:0db8::/64
New vs_531 %flag
Description
Specifies the number of seconds between IPv6 router
>
advertisements. Valid values are from 3 to 1800 seconds.
as shown in the example below.
awplus# configure terminal
awplus(config)# interface vlan4
ipv6 nd ra-interval 60
no ipv6 nd suppress-ra
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6 Commands This new command is used to specify the interval between IPv6 Router Advertisements (RA) transmissions.
IPv6 Commands
no ipv6 nd suppress-ra
25.7