Show Loop-Protection - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

show loop-protection

show loop-protection Command new
Use this command to display the current loop protection setup for the device.
Syntax show loop-protection [interface <ifrange>] [counters]
Parameter
interface
<ifrange>
counters
Exec and Privileged Exec mode
Mode
This command is used to display the current configuration and operation of the Loop
Usage
Protection feature
To display the current configuration status for port 1.0.1, use the command:
Example
Figure 15-2: Example output from the show loop-protection command
To display the counter information for port 1.0.1, use the command:
Figure 15-3: Example output from the show loop-protection interface counters command
for port1.0.1
15.26
vs_531 %flag Switching Commands This command displays the current loop protection setup for the device.
Description
The interface selected for display.
A port, a port range, or an aggregated link.
Displays counter information for loop protection.
awplus #
Loop-Detection:
LDF Interval:
Interface:
Action:
Timeout:
Vlan:
Status:
Timeout Remaining:
Vlan:
Status:
Timeout Remaining:
awplus #
Interface:
Vlan:
LDF Tx:
LDF Rx:
Invalid LDF Rx:
Action:
Vlan:
LDF Tx:
LDF Rx:
Invalid LDF Rx:
Action:
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show loop-protection interface port1.0.1
Enabled
10 [sec]
port1.0.1
port-disable
300 [sec]
1
Blocking
115 [sec]
2
Normal
0 [sec]
show loop-protection interface port1.0.1
counters
port1.0.1
1
3
1
1
1
2
3
0
0
0
C613-50007-01 REV B