Ipv6 Nd Reachable-Time - Allied Telesis SwitchBlade x908 Series Software Reference Manual

ipv6 nd reachable-time

ipv6 nd reachable-time Command
Use this command to specify the reachable time in the router advertisement to be used for
detecting reachability of the IPv6 neighbor.
Use the no parameter with this command to reset the value to default.
Syntax
ipv6 nd reachable-time <milliseconds>
no ipv6 nd reachable-time <milliseconds>
Parameter
<milliseconds>
0 milliseconds
Default
Interface mode
Mode
This command specifies the reachable time of the current router to be announced in IPv6
Usage
Router Advertisements.
Advertisement flags will not be transmitted unless you have applied the
command on page
To set the reachable-time in router advertisements on vlan4 to be 1800000 milliseconds.
Example
awplus(config-if)#
awplus(config-if)#
ipv6 nd suppress-ra
Related Commands
ipv6 nd prefix
C613-50007-01 REV B
New vs_531 %flag
Description
Time period in milliseconds. Valid values are from 0 to 3600000.
Setting the value of 0 indicates an unspecified reachable-time.
25.10. This instruction is included in the example shown below.
awplus# configure terminal
awplus(config)# interface vlan4
ipv6 nd reachable-time 1800000
no ipv6 nd suppress-ra
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6 Commands This new command is used to specify the reachable time in the router advertisement to be used for detecting reachability of the IPv6 neighbor.
IPv6 Commands
no ipv6 nd suppress-ra
25.9