Clear Bgp (Ip Address) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

clear bgp (ip address)

Use this command to reset the BGP connection for specified peers.
Syntax clear bgp <ip-address> [<in>|out|<soft>]
Parameter
<ip-address>
<in>
in
prefix-filter
out
<soft>
in
out
Privileged Exec mode
Mode
Example
awplus#
awplus#
C613-50007-01 REV B
Description
Specifies the IPv4 address of the neighbor whose connection is
to be reset, entered in the form A.B.C.D.
in [prefix-filter]
Indicates that incoming advertised routes will be cleared.
Specifies that a prefix-list will be sent, by the ORF mechanism,
to those neighbors with which the ORF capability has been
negotiated. The neighbors will be triggered to resend updates,
which match the prefix-list filter, to the local router. The local
router will then perform a soft reconfiguration.
Indicates that outgoing advertised routes will be cleared
soft [in |out]
Soft inbound reset causes the neighbors to resend all their
updates to the local switch, without resetting the connection or
clearing the entries in the local switch. So, the local switch
stores new updates, and uses them to systematically replace
existing table entries. This process can use a considerable
amount of memory.
Soft outbound reset causes the switch to simply resend all its
updates to the specified neighbor(s), without resetting the
connection, or clearing table entries.
clear bgp 3.3.3.3 soft in prefix-filter
clear bgp ipv6 2.2.2.2 out
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
38.31