Start-Up Sequence - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Start-up Sequence

Start-up sequence
The start-up sequence for a device running AlliedWare Plus™ under normal circumstances will
be as seen below - this sequence will be seen when everything loads and runs as expected.
Note:
Reading flash:r1-main-20081114-2.rel...
Verifying release... OK
Booting...
Starting base/first...
______________
/\ \
/ \ \_
/ \ |
/ \ \
/______/\____\ \/ /____________/
Allied Telesis Inc.
AlliedWare Plus (TM) v5.3.1
Original release filename: r1-main-20081114-2.rel
Built: Fri Nov 14 13:03:59 NZDT 2008 by: maker@awpmaker06-dl
Mounting virtual filesystems...
Mounting static filesystems...
Mounting flash...
Checking NVS filesystem...
Mounting NVS filesystem...
Starting base/dbus...
Starting base/klogd...
Starting base/loopback...
Starting base/sysctl...
Starting base/syslog...
Starting base/appmond...
Starting base/portmapper...
Starting base/cron...
Starting hardware/openhpi...
Starting hardware/timeout...
Starting base/autofs...
Starting base/inet...
Starting base/modules...
Received event baseboard.found
Received event hardware.done
Starting network/startup...
Starting hardware/openhpilog...
Starting network/trigger...
23:19:53 awplus HPI: HOTSWAP PSU 2 hotswapped in: AT-PWR01-AC
23:19:53 awplus HPI: HOTSWAP FOM 1 hotswapped in: AT-FAN01
Received event network.enabled
Initializing HA processes:
auth, bgpd, cntrd, epsr, exfx, hostd, hsl
imi, irdpd, lacp, loopprot, mstp, nsm, openhpid
ospfd, pdmd, pimd, ripd, ripngd, rmon, vrrpd
Received event network.initialized
Received event standalone
Assigning Active Workload to HA processes:
hsl, lacpd, loopprotd, mstpd, nsm, pdmd, ripngd
rmond, vrrpd, authd, bgpd, epsrd, irdpd, ospfd
pimd, ripd, imi
Received event network.activated
Loading configuration file flash:/ipgw.cfg, please wait.
..
Received event network.configured
awplus login: manager
Password:
AlliedWare Plus (TM) 5.3.1 11/14/08 13:00:27
Bootloader 1.0.9 loaded
Press <Ctrl+B> for the Boot Menu
3.8
To enter the bootloader or diagnostic menus discussed previously, Ctrl+B or Ctrl+D
must be entered when prompted before the software modules start loading.
____
/ /______\
__/ /| ______ |
| / | ______ |
/ / \ ____ /
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
[ OK ]
C613-50007-01 REV B