Show Ipv6 Rip Interface - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIPng Commands

show ipv6 rip interface

show ipv6 rip interface Command
Use this command to display information about the RIPng interfaces. You can specify an
interface name to display information about a specific interface.
To modify the lines displayed, use the | (output modifier token); to save the output to a file
use the > output redirection token.
Syntax
show ipv6 rip interface [<ifname>]
Parameter
<ifname>
Privileged Exec mode and Exec mode
Mode
Example
The following is a sample output from the show ipv6 rip interface command.
Output
34.18
New vs_531 %flag
Description
Optional. Name of the interface for which information has to be displayed.
awplus# show ipv6 rip interface
lo is up, line protocol is up
RIPng is not enabled on this interface
vlan1 is up, line protocol is up
RIPng is not enabled on this interface
vlan2 is down, line protocol is down
RIPng is not enabled on this interface
vlan3 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IP interface address:
3ffe:ffff::1/64
3ffe:fffe::1/64
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIPng Commands Use this command to display information about the RIPng interfaces.
C613-50007-01 REV B