spanning-tree autoedge (RSTP and MSTP)
Use this command to enable the autoedge feature on the port.
The autoedge feature allows the port to automatically detect that it is an edge port. If it does
not receive any BPDUs in the first three seconds after linkup, enabling, or entering RSTP or
MSTP mode, it sets itself to be an edgeport and enters the forwarding state.
Use this command for RSTP or MSTP.
Use the no parameter with this command to disable this feature.
Syntax
spanning-tree autoedge
no spanning-tree autoedge
Disabled.
Default
Interface mode
Mode
Example
spanning-tree edgeport (RSTP and MSTP)
Related commands
C613-50007-01 REV B
awplus#
configure terminal
awplus(config)#
interface port1.1.3
awplus(config-if)#
spanning-tree autoedge
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus
Operating System - Software Version 5.3.1
Spanning Tree Commands
19.23